Cyclone turret alignment issue

All info relating to the Denford Cyclone lathes

Moderators: Martin, Steve, Mr Magoo

Post Reply
Martin
CNC Guru
CNC Guru
Posts: 1901
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Cyclone turret alignment issue

Post by Martin » Tue 14 Dec , 2010 11:32 am

Is it the centre line or centre height that's out?
Top
H12UAJ
Posts: 11
Joined: Tue 25 May , 2010 10:59 am

Re: Cyclone turret alignment issue

Post by H12UAJ » Tue 14 Dec , 2010 13:36 pm

centre line
Top
Martin
CNC Guru
CNC Guru
Posts: 1901
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Cyclone turret alignment issue

Post by Martin » Tue 14 Dec , 2010 13:53 pm

What model of Fanuc control is fitted?
Top
H12UAJ
Posts: 11
Joined: Tue 25 May , 2010 10:59 am

Re: Cyclone turret alignment issue

Post by H12UAJ » Tue 14 Dec , 2010 17:22 pm

GE Fanuc Series 21i-T
Top
Martin
CNC Guru
CNC Guru
Posts: 1901
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Cyclone turret alignment issue

Post by Martin » Tue 14 Dec , 2010 17:40 pm

Do you know if it has datum switches fitted?

You need to reset the X axis home position which is a bit tricky.

There is a procedure sheet that tells you how to set it. I should be able to add a coppy next time I am in the office. (Next Monday)
Top
Martin
CNC Guru
CNC Guru
Posts: 1901
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Cyclone turret alignment issue

Post by Martin » Tue 21 Dec , 2010 17:19 pm

Reference procedure for a Fanuc 21I without reference switches.
Attachments
Refeerence procedure Fanuc 21I.pdf
(24.73 KiB) Downloaded 1197 times
Top
Post Reply

Return to “Cyclone”