We are a high school just outside of Manhattan and have 2 of your products;
Microturn NS (U00706/3) and Compact 1000 (U00687/2). I am new to this but very capable. This machines have been sitting idle for years - determined to make them useful to students. All software installed, connected but now get a fault message. "Machine Connection Problem" with red "could not connect to machine" - now I removed the side and plugged USB directly into the board connector - still nothing. Fuses look good. Any help would be much appreciated! Thanks in advance!
David Di Gregorio
Can not get it to do anything
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 1
- Joined: Thu 18 Jan , 2018 17:18 pm
- Hardware/Software: We are a high school just outside of Manhattan and have 2 of your products;
Microturn NS (U00706/3) and Compact 1000 (U00687/2).
Re: Can not get it to do anything
Have you installed the USB drivers?
Take a look in device manager. The drivers should be on the VRMilling CD's.
Take a look in device manager. The drivers should be on the VRMilling CD's.