I was wondering if the PCB engraver nextmove card should be programmed with a machine type and the machine serial number?
EasyUpgrader2 states it's special and no serial number set.
Is a Denford expert able to confirm what if anything should be programmed into the card NVRAM?
Many thanks,
GIllian
PCB engraver nextmove programming
Moderators: Martin, Steve, Mr Magoo
Re: PCB engraver nextmove programming
The PCB Engraver was never added to EasyUgrader & the PCB software does not look for it so no it does not need to be programmed.
You can put the machine serial number in if you want but it`s not required to run.
You can put the machine serial number in if you want but it`s not required to run.
-
- Posts: 15
- Joined: Wed 12 Jul , 2023 22:41 pm
- Hardware/Software: Novamill 1997, PCB Engraver 2014
Re: PCB engraver nextmove programming
Thank you for the confirmation.