Adding Micromill Support to 2D Des v1.60

A forum for issues relating to the use of TechSoft 2D design and Denford CNC machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
WebbA
Posts: 2
Joined: Thu 20 Sep , 2007 12:45 pm

Adding Micromill Support to 2D Des v1.60

Post by WebbA » Thu 20 Sep , 2007 12:49 pm

Hi there,

Ive inherited a Micromill and 2D Des V1.60 (Labelled as v2?). I have a CD Boxed, labelled as Denford Extension.

How to i install CNC Support for the Micromill? 2D Des doesnt give you the option to simply add a new mill, and when I install the Denford Extensions cd, it installs it to C:\Denford, but doesnt relate or talk to 2d des in anyway?

Any help would be appriciated

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Wed 26 Sep , 2007 11:07 am

Sorry for not answering sooner - your post seems to have been missed.
Techsoft v1.6 is (I think) the pre-release of Version 2 :?

My version of "V2" is called v1.60 in Help -> About
This version is referred to on this forum as V2 and does not contain any support for CNC machines such as Denford or Boxford - only Roland and Graphtec.

Your only option is to get hold of version 1 Techsoft, or use the DXF import function in Version 5 VR Milling (if you have it)

- see this post:
viewtopic.php?t=267

Post Reply