Good morning,
the official seller that provided the lathe (micro turn pro) to my university told them that it is possible to enter a solidworks design directly into the opperating system of the lathe. I have been trying to figure out how it can be done for a week now. Can someone provide me some instructions such as the type of file the solid works design has to be saved as, and the procedure after that ?
Than you in advance !
SOLIDWORKS TO QUICKTURN 2D
Moderators: Martin, Steve, Mr Magoo
Re: SOLIDWORKS TO QUICKTURN 2D
Hi,
If you wanted to export to the lathe directly from solid works you would have to post process the file within solid works.
If you dont have a post processor then you would have to create one.
The information required is available on the forum.
https://www.denfordata.com/bb/viewforum.php?f=16
If you wanted to export to the lathe directly from solid works you would have to post process the file within solid works.
If you dont have a post processor then you would have to create one.
The information required is available on the forum.
https://www.denfordata.com/bb/viewforum.php?f=16