Comms dropping out

Submit any comments, issues or requests relating to the use of VR Milling Version 5 and 2

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
GingerNinja54
Posts: 27
Joined: Mon 28 Jun , 2021 19:46 pm

Comms dropping out

Post by GingerNinja54 » Mon 25 Oct , 2021 22:09 pm

Since purchasing my Triac, I’ve had a few issues around the spindle drive, etc though I’ve now resolved these.
I’ve been checking all operations, referencing, tool changing etc and have been getting issues occasionally where the USB connection drops out.

Whilst an issue with the Baldor board is possible I’m sure, would it be intermittent like this?

Any ideas on getting a more stable connection?
Regards,
GN54

Toolmaker & milling specialist by day...
...bumbling idiot & 'Home-Engineer by weekend & night!
:D

Responses, support and advice is appreciated

Triac VMC (1995) With USB upgrade & VR Milling 5

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: Comms dropping out

Post by Steve » Tue 26 Oct , 2021 16:48 pm

What is the message you get when loosing connection?
Have you checked your PC power saving settings? Make sure the USB is not going into power saving mode.

User avatar
GingerNinja54
Posts: 27
Joined: Mon 28 Jun , 2021 19:46 pm

Re: Comms dropping out

Post by GingerNinja54 » Tue 26 Oct , 2021 18:35 pm

Thanks Steve, I’ll take a look at pc settings.
The pc is active when it drops out, though I’m not sure if there are any background settings for the USB ports specifically? I’ll take a look…

The windows message is “USB device not recognised”
The pop up within VR5 is “The Device driver call failed”

Today I’ve had increasing periods where it was fine, but then I couldn’t clear an emergency stop alarm when rebooting VR5, so I’m stuck trying to resolve that one now…
Regards,
GN54

Toolmaker & milling specialist by day...
...bumbling idiot & 'Home-Engineer by weekend & night!
:D

Responses, support and advice is appreciated

Triac VMC (1995) With USB upgrade & VR Milling 5

User avatar
GingerNinja54
Posts: 27
Joined: Mon 28 Jun , 2021 19:46 pm

Re: Comms dropping out

Post by GingerNinja54 » Tue 26 Oct , 2021 20:27 pm

Steve wrote:
Tue 26 Oct , 2021 16:48 pm
What is the message you get when loosing connection?
Have you checked your PC power saving settings? Make sure the USB is not going into power saving mode.
I wasn’t aware of this, but found my laptop had the settings enabled so would have been powering down the USB port.
https://www.windowscentral.com/how-prev ... sb-devices

Found the details of how to change (for anyone else that it might help)…
Will trial tomorrow and hope the e-stop issue is self-resolved! :) (or I find an answer in the meantime!)
Regards,
GN54

Toolmaker & milling specialist by day...
...bumbling idiot & 'Home-Engineer by weekend & night!
:D

Responses, support and advice is appreciated

Triac VMC (1995) With USB upgrade & VR Milling 5

Post Reply