Page 1 of 1
error no response from controller
Posted: Thu 28 Sep , 2017 13:07 pm
by papa_dogo
getting this error message soon after starting the program: error no response from controller. vr milling 2 on a microrouter v4ns. only way out is to disconnect the machine.
Re: error no response from controller
Posted: Thu 28 Sep , 2017 22:12 pm
by Martin
Are you running any local extraction as it could be causing electrical noise.
It may be worth loading DenfordEasyUpgrader & checking the firmware is up to date on the NextStep control card.