Toolin library
Moderators: Martin, Steve, Mr Magoo
Toolin library
We have just re-installed VRMilling to a replacement computer and up-dated the software to V5.55. All appears to working ok but there is only one tool the tool library (6mm ball nose (default)). From memory I thought this was pre-populated with a large range of tools. Any help please.
-
- Posts: 3
- Joined: Wed 25 Sep , 2013 14:11 pm
- Hardware/Software: Micromill, Micromill2000, Novamill, Microturn
Re: Toolin library
I realize that the previous post is a few years old, but I now have the same situation. A customer of mine has recently upgraded to VR Milling V5.64, and now in his tooling library, the 8MM End Mill tool is not available for selection. Is there a way to add this tool to the library or a procedure that is needed to reveal it as available?
Thank you.
Thank you.