Denford Software & Machines

VR Milling v2.14 and MillCAM 2.22 for AES customers:

Zip image of the CD supplied to AES customers in the USA:
http://www.denfordata.com/downloads/VRM ... 14-AES.zip (167 Mb)

AES Supplied MicroMill and MicroTurn machines into the US Market as an OEM supplier.

They wrote curriculum to be used with these machines which was written around VR Milling 2 and MillCAM Designer 2.22

As a result when the software was updated some of the curriculum screenshots were out of date.

AES Made the decision to continue supplying the older version of software as the curriculum matched perfectly.

All these machines were supplied with DENSTEP control cards as the NextMove card will not run with the older version of VR Milling 2


AES users who wish to use the AES curriculum should download the version of software supplied in this thread.

If you have lost your software but still have it installed on an older PC follow this link to recover the licence key.

viewtopic.php?f=9&t=2543&p=9260&hilit=l ... ware#p9260