Light Machines - Post Processor
Posted: Tue 20 May , 2008 18:50 pm
I need help in getting a post file that will run on our Light Machines educational mill.
the Larken Camtool post does not work...although the G-code looks vary similar...the light machines will not read how the tooling information is written.
I have attached a sample engraving file of a snowflake from the Light Machines Mill software. Perhaps that can help you figure out a post file for the Light Machines mill.
thanks, -OV-
the Larken Camtool post does not work...although the G-code looks vary similar...the light machines will not read how the tooling information is written.
I have attached a sample engraving file of a snowflake from the Light Machines Mill software. Perhaps that can help you figure out a post file for the Light Machines mill.
thanks, -OV-