Post Processor and SolidCAM
Posted: Thu 21 Jun , 2007 15:00 pm
I’m at Applied Engineering Solutions in Maple Grove, MN and we have recently finished up 2 toolpath files in SolidCAM using a FANUCOT post. I have attached them to this message. Last month, Dale Kirchner from LabCorp was at my office as I am looking at the possibility of purchasing a new lathe for the college. We talked about the compatibility of SolidCAM to Denford, and he advised me to send you a toolpath file to work with. These two files are turning files.
If you have any questions, you may speak with Corey Scheich. His phone number is 763-420-6600 and his e-mail is cscheich@ae-solutions.com.
Thank you for your help!
Very sincerely,
Connie Hicks
If you have any questions, you may speak with Corey Scheich. His phone number is 763-420-6600 and his e-mail is cscheich@ae-solutions.com.
Thank you for your help!
Very sincerely,
Connie Hicks