Page 1 of 1
Denford TDS/35/U1P
Posted: Fri 28 Dec , 2012 22:45 pm
by noel1982
I have a rather old Denford milling machine (manufactured in 1986). The model is TDS/35/U1P. I am looking for the manual and parts list. Can anyone help me on this?
Thanks
Re: Denford TDS/35/U1P
Posted: Wed 02 Jan , 2013 10:28 am
by Denford Admin
It's not a number I recognise, can you post a picture ?
It may be worth looking at the Senior and Easimill section to see if they are similar:
viewtopic.php?f=34&t=2564
viewtopic.php?f=53&t=3729
Re: Denford TDS/35/U1P
Posted: Wed 02 Jan , 2013 22:48 pm
by noel1982
Thanks a lot for your reply, I will post a pic asap
Re: Denford TDS/35/U1P
Posted: Fri 04 Jan , 2013 11:08 am
by Andy B
The U1P was the imported and re-badged mill that I understand the Easimill was based on.
There definitely was a manual for these in the old DO, and I thought there was a scan of it on here somewhere - possibly in one of the Easimill threads.
Don't recall if there was a full parts list - there certainly won't be any component drawings as they were neither designed nor built by Denford.
Andy
Re: Denford TDS/35/U1P
Posted: Fri 04 Jan , 2013 11:28 am
by Andy B
A bit more searching - manual for a T1P is here:
https://www.denfordata.com/pdfs/T1P-Turr ... achine.pdf
There is a thread on
V1P machines here
with a link to the manual and parts list for those machines.
I'm guessing 'U' in U1P stood for Universal, whereas 'T' stood for Turret and 'V' stood for Vertical?
A photo or two would certainly aid identification - and add the the Denford history archive!
Andy