I have been asked about machine plates with gear info on, for a Viceroy lathe - I can't find any like that, but have found a few of these if anyone is interested:
Apart from the machine plates I found previously:
I found a few of these as well:
Viceroy anodised machine plates / labels
Moderators: Martin, Steve, Mr Magoo
- Denford Admin
- Site Admin
- Posts: 3635
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Viceroy anodised machine plates / labels
- Attachments
-
- viceroy-plates.jpg (111.62 KiB) Viewed 3492 times
-
- CNC Guru
- Posts: 396
- Joined: Mon 20 Nov , 2006 18:19 pm
- Hardware/Software: 280 VS lathe, Denford Senior E-type mill, Senior Major Universal Mill
- Location: East Midlands, UK
Name that plate....
The round one and the small rectangular one on the right are for the threadcutting dial indicator. One of them is probably to drawing CH246 (can't tell which from the drawing list)
The curved one is appliable to most manual lathes with a threadcutting gearbox, but I have only seen it fitted in pictures of the 'Synchro' models.
'Hardened Slideways' probably drawing CH224
Andy
The curved one is appliable to most manual lathes with a threadcutting gearbox, but I have only seen it fitted in pictures of the 'Synchro' models.
'Hardened Slideways' probably drawing CH224
Andy