I have the following for sale, all in working order:
Air operated 5" chuck made by Leader of Birmingham (still in business) camlock D1-3 fitting with all the associated solenoids, wiring loom, switches, air pipes and the relay board containing relays R4, R5, R6, R7 and fuse 8.
Brown-Pestell single phase KEB Combivert spindle motor drive.
2 off PKS stepper motor driver boards and the driver interface board. One of the stepper drivers shows signs of being hot at sometime in the past, but is still working.
CRT monitor and the associated KME MB12 board.
Keypad board with the attached VDU processor board.
PNC main processor board which is populated with 8 relays.
Front panel, very clean, unscratched with a cassette drive attached.
2 spare cassette units and 2 data tapes.
Regards,
John.
EASITURN 3 PARTS FOR SALE
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 3
- Joined: Wed 24 Feb , 2010 17:37 pm
Re: EASITURN 3 PARTS FOR SALE
Hi John
I would like to purchase the tape drives and spare cassettes. I assume from all the electrical gear you are selling you are upgrading the electronics on your easiturn, how is it going. At one time I was going to do the same but decided to stick with the current setup until something breaks!
Steve
I would like to purchase the tape drives and spare cassettes. I assume from all the electrical gear you are selling you are upgrading the electronics on your easiturn, how is it going. At one time I was going to do the same but decided to stick with the current setup until something breaks!
Steve
Re: EASITURN 3 PARTS FOR SALE
Hi
I am interested in the chuck can you let me know how much you want for it? You can contact me on 0115 9703765 or 07813 481850 or via email david@davidcolwill.com
David
I am interested in the chuck can you let me know how much you want for it? You can contact me on 0115 9703765 or 07813 481850 or via email david@davidcolwill.com
David
-
- CNC Guru
- Posts: 525
- Joined: Tue 14 Nov , 2006 12:12 pm
- Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3 - Location: Quatroland
Re: EASITURN 3 PARTS FOR SALE
not sure if you still have the stepper drivers and spindle drive, if so can you pm me details please.
Re: EASITURN 3 PARTS FOR SALE
Hi
Have you any of the main electronic boards left for sale for the Easiturn 3?
Regards
Adee
Have you any of the main electronic boards left for sale for the Easiturn 3?
Regards
Adee
-
- Posts: 13
- Joined: Tue 25 Nov , 2008 17:48 pm
Re: EASITURN 3 PARTS FOR SALE
Do you still have the Keypad board ,what is the price for it ?
Replay me to kmitronikas@hotmail.com
thank you in advance
Replay me to kmitronikas@hotmail.com
thank you in advance