Hi I am after an auto tool changer for a Denford Cyclone Lathe. I would also like to get in touch with anyone who considers themselves qualified to offer help, advice and/or maintainence on the Cyclone. I am willing to pay for the correct help and any support would be greatly appreciated.
Phil
Denford Cyclone
Moderators: Martin, Steve, Mr Magoo
Re: Denford Cyclone
What control system does your Cyclone have Phil?
-
philog4559
- Posts: 15
- Joined: Thu 07 Apr , 2011 13:23 pm
Re: Denford Cyclone
Hi Martin
The machine uses a Fanuc control system.
The machine uses a Fanuc control system.
-
philog4559
- Posts: 15
- Joined: Thu 07 Apr , 2011 13:23 pm
Re: Denford Cyclone
Hi Martin
Sorry about my lack of knowledge with this machine, but having looked through the forum and read some of the posts, the machine is controlled from a floppy disk using a DOS based software. Hope this helps a little.
Regards
Phil
Sorry about my lack of knowledge with this machine, but having looked through the forum and read some of the posts, the machine is controlled from a floppy disk using a DOS based software. Hope this helps a little.
Regards
Phil