None of the springs should be flipped they should all be fitted oposing each other and the 10.5 should be standard for all.

As martin says the files are produces in Quick Cam pro with the back of the car at the left and with the Rotary fixture you have the back of the car on the right. You have to add a mirror in X command to make it cut right to left with the origin on the RH end. If using Car Wizard you can output to t...

The machine was probably supplied with a seperate autotrancformer in a box. this would convert the 110V to 230 or 240V.

With the introduction of the F1 Model Block made of foam the bore of the billet was reduced to 18mm.

As a result the spiggot is now a smailler dimension

Using Easy Upgrader the card can be used for any machine and will update any machine running without a USB port.
Replacing a Denstep controller performance would be much improved.
.

Hi, The machine RS232 cable will be detIle on the forum. I would also check the EPROM version you have in the machine. If the EPROM is for DOS the software can be downloaded for free if the EPROM is for VR Turning you would have to purchase software from Denford. The serial cable for US machines is ...

Hi,

The Turn270PRO will not cut does not have a command for taper thread cutting.

The spindle only runs in reverse.

Just call Denford or email Sales@denford.co.uk

Locknut BI00186HH

The price has increased a bit but they are in stock

Headstock Drawing

This file can be downloaded to produce a pully system to tension the tether guide. pulley.jpg PULLEY BRACKET (9.1.18).stl The STL can be 3D Printed and one of the F1 in school axles can be used as a shaft for the pulley The pulleys can be purchased through Rapid Electronics https://www.rapidonline.c...

It sounds as if the machine does not have microstepping drives/

Post a picture of the electrical panel and the serial number plate.

The center drill has a 2mm tip but 5mm shank so to be used the hole must be drawn as 5mm.

If you set the depth to 2mm it will only use the start of the centre drill.

It would then use the 5mm drill to drill 2mm deep also unless you dissablesd it in the tool library.

A usefull setting gauge for router tooling if not using the recommended tool holders.

Set tool one on the surface of the material with a Zero offset and other tools have an offset of either -20, -25mm or -30mm.

Hi, What spindle speed were you trying to run at? If the speed request was very slow it may not have enough grunt to start rotating. Set the speed to say 1500RPM with the override to 100% and see if there is any difference. It could also be an issue with the spindle analogue. The light dimming would...

Denford manufacture thier own turret for the current machines which are not retrofitable onto the Cyclone.

Hi, The serial cable you are using does not look to be the correct one. It should be a Black Lindy cable and is not an off the shelf serial cable. The cable should be a BI01812GG https://www.denfordata.com/bb/viewtopic.php?f=54&t=765&p=23012&hilit=serial+rs232#p23012 https://www.denfordata.com/bb/vi...

Hi Max,

I dont think we have any Hex files now.

The IP address will be displayed at the top left of the start gate screen.

Using an ethernet cable is covered in the race system manual from page 18.

I have attached the manual

I cant see why it would not be possible.

The thread routine would have to cut from the chuck towards the tailstock to keep the spindle direction the same and use the same tool.

Quick Turn 2D writes threading routines this way for LH threads.

The software is available from Denford. Contact sales@denford.co.uk