Thanks for the scans;

In the end, I fixed the broken screw and tried, and as expected the regulation works perfectly.

So problem solved!
Thanks for the support!

Ok,
I managed to remove the broken pin, now I need to understand how the adjustment works.

Can you see any issue from the picture attached?
I guess it’s an eccentric bush that change the position.

Thanks,

Unfortunately I have not fix it yet.

I’ll try to remove the broken bolt today (welding a nut?)

I looked in the download section but appear to be different.
If you cs. Upload a picture that would help.

I’ll post updates later

Hello guys, I’m having lots of issue disassembling the tail stick of my viceroy. I need to do it cause the adjustment is completely off, and I need to understand how to make it work. I think the adjustment is a lever on the side that broke a certain point in his life. Can you please help me telling ...

Open the door,
(Carefully please) please a finger on the x axis trying to stop it.
Jogging the axis, and trying to stop it with your hand, are you able to stop it?

The board connection are similar to v5, but is not v5. You don’t have a timer or separated driver for the motors. On your board, in TB9 (bottom, third group from left), you have 3 cables, should be numbered 78 77 and the third is ground. That’s guard contact 1. Have a look. I removed it from my Bob....

Let me start with, I have not read all the pages; Why don’t you bypass the switch? Can you post a picture of the diagramS where there is the problematic switch so I can have a look? I had a similar problem with an axis not going fully through. It you move the axis in a position where it goes left an...

I’ve seen your router for sale mate, I think you priced it correctly, actually looks a good price to me.

Good luck!

I already looked at it but I’ll look again.

My problem is the SGR enabler, I don’t understand what value take to enable it.

Do you know how the SGR works? Or better, what’s the enabler signal value expected?

My current worries is: the enable of the SGR (top right signal from out2 of the Bob) is +24v, -24v or 0?

Can you help?
I’m not 100% sure the connection on OUT1 and out2 are correct to activate the SGR

I’m still looking at it,
I would like to keep them, but if I don’t figure out how to control it, I have to jump them.

Thanks for the feedback David. The main power supply for that board comes from a SGR and timer; My current understanding is that the timer count from when you close the Cnc door, and than power the SGR. Both timer and SGR seems driven by a 24v supply. Tomorrow I’ll check the power source of the spin...

Hello guys, I’m new to the forum, and I’m in looking for confirmation on the spindle board; I would like confirmation on the connection: L1 and L2 are the main power 220v A+ and A- are the output to the spindle motor Now the real question: P1 is the negative 0-10v P2 is the positive 0-10v So if I co...