Search found 6 matches

Final update. I mangage to get it running by removing the driver board and jumping the pins on the 96 pin connector.
Too easy.
I've ordered a breakout board and some single pin connectors from ebay. Total cost was about $12.
I'm using Mach3 and everything seems to be going well.

I have an update on my lack of progress.
I went with option 2, wire my board straight to the stepper motors at the lathe and see if that would work.
It didn't.
I removed the wires from the orange connectors and connected them to the board I use to run my mill. My mill runs fine on Mach3. I can run ...

Texas , US

2.0B/10/S/B/B19/JD5
The seven segement display is red.

Can I grab some legacy software from here https://website.denford.ltd.uk/support/90-dos-info/106-dos-software
Use the Flashes.txt to unlock the software and use that to run my Microturn lathe?

I can dig up a WIN98 disk and setup an older computer to run the software.
IF all the above is correct do ...

Greetings all. I'm new to the board and need some assistance.
I recently purchased a microturn lathe and as usual there was no computer or software that came with it.
I have Mach3 and a driver board that I use for my mill.

I read through the forum and it seems I have a choice to bypass the original ...