Search found 3 matches

Have you got a number i can call you on?

Thank you Denford Admin,all helpful stuff.
Yes Alanhende repair would be good but depends on cost as always.
I dont think it can be much as all the cassette commands come up on the screen as they should and
you can hear the tape unit motor(i think) running but the spindles dont turn????
Where are ...

Hi to you all, i am new to this forum and I have just got my easimill after many months of looking, the tape recording system is not working so i was hoping that you guru's out there could walk me(very slowly as new to this cnc stuff) through converting my machine to run off mach 3????
In the short ...