Search found 12 matches

thanks gonna check.

Lasse
www.Kompositmekanik.se

spindle spins only 50% rpm
I have 10 volts in (10v = 400 rpm) but it rotates only in 2000
someone who has a good tip?

the image is on the control board

thanks I have thought about it
so is there anyone who has tried any?
has anyone changed the motor?
has anyone changed the pully?

triac spindle speed

hey I mill with 1-3mm cutters so I would like to get up speed from 4000 to 8-20000
is there anyone who has done it?
it is possible to change gear so that the alternate 6000 rpm but is there some other way?
then it would be helpful to know what problems may arise.
ball bearings ...

triac electronics for sale
everything works
cheap
things are in Stockholm, Sweden
see photos

lasse@kompositmekanik.se
https://www.kompositmekanik.se

Thank you all.
I like the idea of home sensor.
is there anyone else who has done it with the original home sensor?

Ha ha it was creative!
my card looks like this.
you can find where to solder the cables.
is there anyone who knows?

Thank you very much:)

I contacted buffy and they did not know what type it was and the part number was nothing they were aware of
So how does anyone who uses geckodrive or mach3 done with your home sensors?

please someone know how they work?

Thanks for the information, but if you search the Internet there is no info about the sensor.
So is there anyone who knows what type of sensor, data and wiring. It looks a bit poorly on the image

hi i would like to know what type of sensor and brand and data so I can try them
the mill is from 1993 or 94

Recently purchased a triac from September 1993 and like to mill 3D.
How do I do?
What should be upgraded?
What does it cost?
Where can I buy it?
Or should I throw it all out and ignore the tool changer and buy the new steering system?
In my work I use powermil as cam programs, there is no record of ...