Search found 8 matches

Hi there

Thank you for all the effort. Unfortunately it's unlikely I will come on your place the next.
Anyway Thank for all the information soon.

regards
Eyup

Hi there

It is realy nice of you to offer me to come over. I'm in Northampton and you.
I have a miling machine and a lathe which I want to convert to Mach3.

Hope I can see you soon.

regards
Eyup

I have finally taken the plunge and stripped out my PKS Digiplan drivers and Lynx 08 spindle drive from my Triac to build it into a seperate panel for control by Mach3.
As such I have the Triac Motherboard, green screen monitor, and front panel available, in fact everything that wasn't fastened to ...

How difficult would the conversion you plan be ?, & how much would it cost, my funds are very limited at the moment so a repair of the current panel is probably my only option untill such a time as I have the funds to upgrade it.
Cheer's.
Bob.

Hi Bob

I'm sure you can repair it and I will contact ...

Hi there

I have a problem with my Triac build Sept./1985 SN 120650/2. Normally when I switch it on I have to Power it and press the button Abs Datum and the axis go to there datum. Recently the machine starts with a message Keys pressed: and few numbers like 55 33 36. When I press than on the ...

Hi there

I'm not sure if you still have some stuff for your Triac. I need for my TRiac sep./1985 a front panel for input.

Thank you
Best regards
Eyup

Hi there

I put recently a request in the forum about a malfunction on my Triac from Set./1985.
The front panel which is the control with all the functions is broken down. Does somebody know where I can buy a spare unit?

Thanks
eyupyupi

Hi there

I have a problem with my Triac build Sept./1985 SN 120650/2. Normally when I switch it on I have to Power it and press the button Abs Datum and the axis go to there datum. Recently the machine starts with a message Keys pressed: and few numbers like 55 33 36. When I press than on the cycle ...