Got it working.
I have put them all in the gnd at the 12-24 v gnd pin.
It does work but I do wonder if I should put them in the PC-GND pin
Bert

Hi I have purchased a new 5 axis BOB. I am converting a Denford microrouter to run MACH3, I have purchased a break out board but it did not have indipendant GND conections for the stepper drivers. I have at the moment conected them all to the GND where the 12-24 v goes. Has any one had the same issu...

Hi.
Hmm On the 200m meter setting it reads 01.0, and that is the same if I touch the meter leads together.
Price ? don't know what they are worth.

Not sure how to test it
checked with meter and all I can say is it does not have an open circuit.

Hi I think this is the one

Hi I shall have a look tonight. pretty sure there is on still fitted not being used.

So a few table size tweaks and all other controls spindle control and home switches will already be configured.

I see in previous posts that v5 can take in a drawing and create the g m codes required so it would do the same as sheetcam.

Is there any demo software available

Hmm Thanks for last post. I have done a Orac conversion but never quite got my head around Mack3 fully. And rather fancied not having to be field engineer just a end user I dont' understand what the VR software actually does, is it the same as mack in principle. I have used scetch-up to do some basi...

No actual software came with it is what is stamped on cabinet.

How much to up grade and does it involve wiring

How do you get a drawing in to v2

Hi I have managed to get a 2003 Microrouter. The one with the drivers and electronics in the back of the cabinet Looks in virtually unused condition. very clean Software version 2.19 It came with two leads one I think is a rs32 on both ends and one that looks like a monitor plug on one end and a rs3...

This time I was to slow to purchase the machine
I will keep a look out now I know more

Oh the joys of the cnc word How hard can it be. I would have liked to have a machine that is simple to operate and program. An all in one package would be great Obviously I am on a tight budget as this is never going to be any more than a hobby machine to play with. It would probably be more cost ef...

Hi It is Software VR2.14 Model V3 So what should I need to do if I got it. what is a fnc file Obviously I will need to be able to draw the item first somehow and then do something with the drawing presumably put it through a cam program. Then send that to the machine program. I take it I will need a...

Hi yes sorry it is black
I have been playing with Mack3 for awhile
So the Denford software is what makes it work does it have a cam program built in so I could send drawing to it and let it work it out.

Cant say I have seen a black box just a large separate whit tower that has a massive oblong plug that goes to the machine

Ok
Going to find it out what it is today
Does the software only operate the machine or is there any drawing package in it

Ok
So I need to find out what version / model number of the big white tower it has with is first
Is it marked on the outer casing

Many thanks it does have a rs232 plug and some other smaller ones. Is the software expensive to buy and would I need a dongle. Just wondering if I could load a program on a separate p.c. take it to the machine and see if it works Where on the machine would be the date of manufacture. I do have an op...

Hi I am thinking of getting a micro router. I have found one that has the external computer box with it. Presumably all the drive boards and power supplies are in it. The vendor is unable to demonstrate it working as it is in a second hand shop. And does not know anything about it or model number. I...

Hi I might have one

I will need a photo of the one you have as I don't know what it looks like but as I am using a vfd you might be in luck
bert