error no response from controller
Moderators: Martin, Steve, Mr Magoo
-
papa_dogo
- CNC Apprentice
- Posts: 38
- Joined: Sat 08 Jun , 2013 0:54 am
- Hardware/Software: microturn/vr turning/lathecamdesigner
micromill/vr milling
error no response from controller
getting this error message soon after starting the program: error no response from controller. vr milling 2 on a microrouter v4ns. only way out is to disconnect the machine.
Re: error no response from controller
Are you running any local extraction as it could be causing electrical noise.
It may be worth loading DenfordEasyUpgrader & checking the firmware is up to date on the NextStep control card.
It may be worth loading DenfordEasyUpgrader & checking the firmware is up to date on the NextStep control card.