All info relating to the Denford Triac series of CNC milling machines
Moderators: Martin, Steve, Mr Magoo
-
ricey3
- Posts: 31
- Joined: Wed 10 Apr , 2013 8:41 am
- Hardware/Software: Starmill running mach3
Post
by ricey3 » Sun 03 May , 2015 16:24 pm
Hi there all.
After a bit of help.
ive just taken delivery of a triac vmc. Serial number Tr19057f.
Refering to the info available i though this might of been coming with the user console hung on the side of it but it seems to be a PC machine. I dont have a PC with it though.
Electrical control box has a floppy drive on the side of it as well as a 3 pin plug outlet that i guess is for powering said pc. Also as far as i can tell has undergone a factory upgrade, perhaps allowing it to take instruction via USB and the latest VR software?
If someone could take a look at my photos and confirm what i have/ will need i'd be most grateful.
The conduit that comes from the e-stop box on the right hand side of the machines also contains a number of d-type connectors that are seemingly unused but are confussing me slightly. Guessing that the wiring is made to work on all variants of VMC and they would be used if the user console was fitted.
-
ricey3
- Posts: 31
- Joined: Wed 10 Apr , 2013 8:41 am
- Hardware/Software: Starmill running mach3
Post
by ricey3 » Sun 03 May , 2015 16:26 pm
-
ricey3
- Posts: 31
- Joined: Wed 10 Apr , 2013 8:41 am
- Hardware/Software: Starmill running mach3
Post
by ricey3 » Sun 03 May , 2015 16:26 pm
-
ricey3
- Posts: 31
- Joined: Wed 10 Apr , 2013 8:41 am
- Hardware/Software: Starmill running mach3
Post
by ricey3 » Sun 03 May , 2015 16:27 pm
Last edited by
ricey3 on Sun 03 May , 2015 16:34 pm, edited 1 time in total.
-
ricey3
- Posts: 31
- Joined: Wed 10 Apr , 2013 8:41 am
- Hardware/Software: Starmill running mach3
Post
by ricey3 » Sun 03 May , 2015 16:27 pm
-
ricey3
- Posts: 31
- Joined: Wed 10 Apr , 2013 8:41 am
- Hardware/Software: Starmill running mach3
Post
by ricey3 » Sun 03 May , 2015 16:28 pm
-
ricey3
- Posts: 31
- Joined: Wed 10 Apr , 2013 8:41 am
- Hardware/Software: Starmill running mach3
Post
by ricey3 » Sun 03 May , 2015 16:29 pm
-
ricey3
- Posts: 31
- Joined: Wed 10 Apr , 2013 8:41 am
- Hardware/Software: Starmill running mach3
Post
by ricey3 » Sun 03 May , 2015 16:30 pm
-
ricey3
- Posts: 31
- Joined: Wed 10 Apr , 2013 8:41 am
- Hardware/Software: Starmill running mach3
Post
by ricey3 » Sun 03 May , 2015 16:30 pm
-
ricey3
- Posts: 31
- Joined: Wed 10 Apr , 2013 8:41 am
- Hardware/Software: Starmill running mach3
Post
by ricey3 » Sun 03 May , 2015 16:31 pm
