Hi All,
i purchased a Cyclone p with a fanuc 21iT control, all is good apart from the previous owner let the batteries die! no backups or data sheets
its taken a year but i'm nearly there, got it running a simple job last night, but i have had to short out the axis lube float switch because the alarm is permanently on, and the spindle still runs when the program reads M00,
does anyone have a list of keep relays?? i realise there may be differences between machines but it may give me some info to work on.
i have the machine in my garage and i am currently making a large scale traction engine, hopefully this machine will help me with the bolts and studs, i hate making repetitive parts on manual machines!!
all the best,
Chris.
cyclone p with 21iT
Moderators: Martin, Steve, Mr Magoo
Re: cyclone p with 21iT
Hi Chris
Do you have the serial number for the Cyclone.
We should have a copy of all the specific settings on record at Denfords.
Do you have the serial number for the Cyclone.
We should have a copy of all the specific settings on record at Denfords.
-
- Posts: 3
- Joined: Fri 20 Nov , 2020 9:13 am
- Hardware/Software: Denford Cyclone p with Fanuc 21iT
serial no, 90824A
year, 2000
electrics serial no, E996A0194
software version, C.009E
machine in mechanically nice condition but the previous owner let the batteries die!!
Re: cyclone p with 21iT
Hi Martin,
yes, if you look to the right hand side of my post the info is in the box,
do you know if its possible for the spindle to stop when the control has read M00?
thanks for your help on this,
regards,
chris.
yes, if you look to the right hand side of my post the info is in the box,
do you know if its possible for the spindle to stop when the control has read M00?
thanks for your help on this,
regards,
chris.
Re: cyclone p with 21iT
Hi Chris
This is the original record sheet for your machine with the timers, counters & keep relay settings.
Hope this helps.
This is the original record sheet for your machine with the timers, counters & keep relay settings.
Hope this helps.
- Attachments
-
- 90824A.DOC
- (16.5 KiB) Downloaded 390 times
-
- Posts: 3
- Joined: Fri 20 Nov , 2020 9:13 am
- Hardware/Software: Denford Cyclone p with Fanuc 21iT
serial no, 90824A
year, 2000
electrics serial no, E996A0194
software version, C.009E
machine in mechanically nice condition but the previous owner let the batteries die!!
Re: cyclone p with 21iT
Brilliant, fantastic service,
all the best,
Chris.
all the best,
Chris.