Triac Fanuc OM-C Drip Feed
Posted: Thu 18 Apr , 2019 2:58 am
Hi All,
I have a 1993 Triac ATC with a Fanuc OM-C Controller and i would like to enable drip feeding.
i can send programs either way from an RS232 cable, but i seem to have a very limited memory, my controller is telling me i only have 4095 i assume bites, apparently the machine had a memory upgrade but i had to re enter the parameters after loosing them so the extra memory may not be enabled.
I have looked in the ladder and i do have G127.5 but i dont have a tape switch, i can find lots of info about changing Diagnostics and parameters to enable drip feeding, there seems to be lots of different ways to do it i am just not sure what way to go.
any help would be much appreciated.
cheers,
Tom
I have a 1993 Triac ATC with a Fanuc OM-C Controller and i would like to enable drip feeding.
i can send programs either way from an RS232 cable, but i seem to have a very limited memory, my controller is telling me i only have 4095 i assume bites, apparently the machine had a memory upgrade but i had to re enter the parameters after loosing them so the extra memory may not be enabled.
I have looked in the ladder and i do have G127.5 but i dont have a tape switch, i can find lots of info about changing Diagnostics and parameters to enable drip feeding, there seems to be lots of different ways to do it i am just not sure what way to go.
any help would be much appreciated.
cheers,
Tom