Hi guys,
Not knowing DOS that well, how do you update the software.
I have a starturn 5, and had to swap its hard drive to another PC.
Success it fires up but when running fanucsld. It runs
Comes up with some dates and so then says RS232 disconnected, keyboard disconnected and the code comes up and aborts program.
I assume I need to configure the com ports being in a newer PC but question is how?
I will rebuild PC again securing hard drives and so on
Any help appreciated
Mel
Updating software
CNC related queries on software; firmware; DOS; Windows; parameters; programming; error messages etc.
Moderators: Martin, Steve, Mr Magoo
Jump to
- Welcome
- ↳ Please read these first...
- ↳ Announcements
- CNC / Machines
- ↳ Machines
- ↳ Compact 1000
- ↳ Cyclone
- ↳ EasiMill / EasiTurn
- ↳ Meteor
- ↳ Micromill / Microturn
- ↳ MicroRouter
- ↳ MicroRouter Compact
- ↳ MicroRouter Vertical / MaxiRouter
- ↳ Mirac
- ↳ Novamill
- ↳ NovaTurn
- ↳ Orac
- ↳ PCB Engraver
- ↳ Quatro
- ↳ Router 2600
- ↳ Senior (Tom)
- ↳ StarMill
- ↳ StarTurn
- ↳ Triac
- ↳ Triton
- ↳ Turn270
- ↳ VersaLaser
- ↳ Viceroy
- ↳ VMC 1300
- ↳ ZeroCentre/ZeroTurn/ZeroBore
- ↳ Electronics
- ↳ Software
- ↳ Downloads
- CAD / CAM Software
- ↳ QuickCAM / LaserCAM 2D Design
- ↳ QuickCAM 3D/PRO/4D
- ↳ QuickTURN 2D Design
- ↳ TechSoft 2D Design
- ↳ Post Processors
- ↳ Solidworks
- ↳ VR Milling - All Versions
- ↳ VR Turning - All Versions
- ↳ Other CAD CAM and CNC
- 3D Printing / Rapid Prototyping
- ↳ UP! 3D Printer
- General
- ↳ Project Of The Week
- ↳ Denford Classifieds
- ↳ F1 / 4x4 / GT Racing In Schools
- ↳ Suggestions and Feedback
- ↳ User Stories / Projects / Courseware
- CIM
- ↳ Robots / CIM / VR CIM
- Random Picture Galleries
- ↳ Vintage Pictures