VR Robot + VR CIM “Access Violation error”
Moderators: Martin, Steve, Mr Magoo
- bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
VR Robot + VR CIM “Access Violation error”
VR Robot + VR CIM “Access Violation error”
- bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
Q. After installation of VR Robot + VR CIM we get a “Access Violation error in VR_Link.exe” when trying to run a Robot or CIM room, when trying to close the application down we get the same error message
A.I did a clean installation and got the same error message, I tried changing NFDM from 1 to 0 without that solving the problem, I then ran VISCAPESVR.EXE from the installation directory and that worked fine with NFDM still set at 1
A.I did a clean installation and got the same error message, I tried changing NFDM from 1 to 0 without that solving the problem, I then ran VISCAPESVR.EXE from the installation directory and that worked fine with NFDM still set at 1