Quatro Drwinings

What little info there is on the QuatroMill

Moderators: Martin, Steve, Mr Magoo

Post Reply
streethawk
Posts: 3
Joined: Tue 08 Nov , 2016 9:20 am
Hardware/Software: Quatro mill
Triac mill
Cyclone lathe

Quatro Drwinings

Post by streethawk » Tue 08 Nov , 2016 9:22 am

Hi
I have Quatro mill with Heidenhain 355B control, it's been sitting around for a while and I would like to get it up and running,
I don't seem to have ant electical drawinings for the cabinet or the Heidenhain control parameters any assistance with these two topics would be greatly appreciated

Model QUATROMILL
Serial No QM03079 A
Despatch Date OCTOBER 1989
Serial No Of Electrics 2867431

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: Quatro Drwinings

Post by Martin » Tue 08 Nov , 2016 10:02 am

Hi Steve.

I can't locate the electrical drawings at present but hope this helps.
Attachments
PARAM-D.TXT
(4.77 KiB) Downloaded 506 times
heidenhain-tnc-355-operating-manual.pdf
(10.74 MiB) Downloaded 872 times
Heidenhain TNC 351- 355 Service Manual.pdf
(2.87 MiB) Downloaded 500 times

Andy B
CNC Guru
CNC Guru
Posts: 396
Joined: Mon 20 Nov , 2006 18:19 pm
Hardware/Software: 280 VS lathe, Denford Senior E-type mill, Senior Major Universal Mill
Location: East Midlands, UK

Re: Quatro Drwinings

Post by Andy B » Sat 12 Nov , 2016 22:09 pm

I've put some wiring diagrams here
Hope some of them help.

Andy

streethawk
Posts: 3
Joined: Tue 08 Nov , 2016 9:20 am
Hardware/Software: Quatro mill
Triac mill
Cyclone lathe

Re: Quatro Drwinings

Post by streethawk » Mon 21 Nov , 2016 17:23 pm

Martin wrote:Hi Steve.

I can't locate the electrical drawings at present but hope this helps.
I appreciate the parameters and electrical drawings. I've input the parameters but when I start up it immediatley shows gross position error D, I've tried changing the values in MP57 and MP169 but all that seems to achieve is the Y axis lurging and a gross position error A occuring.

Any help or advise?

Post Reply