ref quatro running heidenhain 355
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 16
- Joined: Wed 11 Jul , 2012 19:01 pm
- Hardware/Software: Denford Quatromill any help in setting up etc appreciated as we have just got one from auction- has a heidenhain controller- and seems good nick no backlash in screws etc- have any members any experience of this well built machine- thanks mike
ref quatro running heidenhain 355
Hi I go to reference the axis and comes up with z axis drive fault motor seems free but any ideas- Mike
Re: ref quatro running heidenhain 355
Check the 3 axis drives in the electrical box. You should have 3 Norwin drives in a rack. Check that all 3 have a green LED lit.
-
- Posts: 16
- Joined: Wed 11 Jul , 2012 19:01 pm
- Hardware/Software: Denford Quatromill any help in setting up etc appreciated as we have just got one from auction- has a heidenhain controller- and seems good nick no backlash in screws etc- have any members any experience of this well built machine- thanks mike
Re: ref quatro running heidenhain 355
the 2on the left are green the one on the end is red?
Re: ref quatro running heidenhain 355
Can you swap them over?