Micromill 2000 - Getting random error (Error: No Response from Controller) on screen, everything still runs OK even after clicking "OK" button.
Any idea why & what the issue might be?
Error: No Response from Controller
Moderators: Martin, Steve, Mr Magoo
-
Fouad Baidoon
- Posts: 1
- Joined: Tue 10 Oct , 2006 14:03 pm
- Location: Farmington Hills, MI USA
Error: No Response from Controller
microrouter micromill 2000 microturn 2000
-
Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
This is an indication of electrical noise causing communication errors
If its an RS232 connection, then check that your internal cable has more than three wires going from the 25 way bulkhead connector, to the Baldor control card (with the 7-segment display) - certain Micromills were supplied with a 3 wire internal cable that we found cause RS232 errors.
If its USB (or RS232) then you should also update the cards firmware (ONLY if it is a control with a GREEN seven segment display)
Download and run the easy upgrader from here:
http://www.denfordata.com/downloads/eas ... 1-4-cd.zip
If none of this makes sense, let us know more about what control you have, what software, what you are cutting - using dust extraction ?, USB or RS232 connection ....
If its an RS232 connection, then check that your internal cable has more than three wires going from the 25 way bulkhead connector, to the Baldor control card (with the 7-segment display) - certain Micromills were supplied with a 3 wire internal cable that we found cause RS232 errors.
If its USB (or RS232) then you should also update the cards firmware (ONLY if it is a control with a GREEN seven segment display)
Download and run the easy upgrader from here:
http://www.denfordata.com/downloads/eas ... 1-4-cd.zip
If none of this makes sense, let us know more about what control you have, what software, what you are cutting - using dust extraction ?, USB or RS232 connection ....