Digiplan sd2 stepper driver
Moderators: Martin, Steve, Mr Magoo
-
- CNC Expert
- Posts: 101
- Joined: Wed 20 Mar , 2013 22:34 pm
- Hardware/Software: Denford Triac PNC3
FeatureCam - CADCAM
Delcam Powershape
Digiplan sd2 stepper driver
Does anyone now where I can get a sd2 digiplan stepper driver repaired, my x axis has given up now.... my fault, accidentally shorted out the 24v ground to the 24v+ that is connected to the 24v on the driver board, (note to self not to do that again!) Or if anyone has any replacement driver's?