Optimized Control D771 S

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
rockermani
Posts: 1
Joined: Sat 22 Dec , 2012 2:00 am

Optimized Control D771 S

Post by rockermani » Sat 22 Dec , 2012 2:17 am

Hi,

I'm new here. Thanks to everyone for making this group a huge success.

I'm wondering if anyone has a schematic of the D771. Not an interconnection diagram but a proper electronic schematic showing component references.

Thanks in advance,

Roc.
Top
User avatar
Denford Admin
Site Admin
Posts: 3634
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: Optimized Control D771 S

Post by Denford Admin » Wed 02 Jan , 2013 10:15 am

We won't have anything like that here, only Baldor would have that much detail.
However, depending on what you're looking for you may find the installation manual has enough detail:
viewtopic.php?f=54&t=3406
Eg, page 26 shows a block diagram of the opto-isolated analogue output which should help you identify components on the board itself
Top
Post Reply

Return to “Electronics”