Hi all, new on here. I have a model of the subj lathe which came from a school to me via one of the Faberge family and my dad. It's in reasonable shape and largely original except for a single phase motor and t-slotted cross slide.
I am contemplating the addition of an ELS set up in order to extend its usability (for me). This would probably require coolant. Can anyone point me in the direction of a dimensioned drawing for part ML124 (a or b) Splash Guard?
Having trawled through the available documents I cannot find one.
Thanks in advance,
Andy
New kid with TDS3 CM&WL
Moderators: Martin, Steve, Mr Magoo
-
- CNC Expert
- Posts: 156
- Joined: Tue 03 Jun , 2014 15:20 pm
- Hardware/Software: None. I own a pre CNC Denford 280 Synchro lathe.
Re: New kid with TDS3 CM&WL
Sorry to be ignorant, but what is ELS?
-
- Posts: 6
- Joined: Fri 17 Jul , 2020 11:12 am
Re: New kid with TDS3 CM&WL
Electronic Lead Screw. Part automation but not full CNC.
Regards,
Andy
Regards,
Andy