Body part screw thread

All info relating to Viceroy machines - Lathes, sharpedge, drills etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
quintain
Posts: 1
Joined: Sun 24 May , 2020 16:06 pm
Hardware/Software: DST Viceroy Educator wood latte, 48"L x 5"C/L with bowl turning head

Body part screw thread

Post by quintain » Thu 11 Jun , 2020 10:06 am

Hello,
I am servicing my v dusty old DST Educator Viceroy wood lathe Ser No TDS 6 1415
What screw thread is used on such as the back top of drive belt cover at the headstock.
It appears to be a M6 bolt with a 1.25 thread (BTW that is the extent of my thread knowledge).
BUT would such an old UK machine use an M6 bolt irrespective of the unusual thread pitch i.e. 1.5 rather than 1.0
I am embarrassed asking such a simple question but I cannot get an answer from a load of 'online' tech info.

Regards
Richard

Andy B
CNC Guru
CNC Guru
Posts: 396
Joined: Mon 20 Nov , 2006 18:19 pm
Hardware/Software: 280 VS lathe, Denford Senior E-type mill, Senior Major Universal Mill
Location: East Midlands, UK

Re: Body part screw thread

Post by Andy B » Fri 12 Jun , 2020 19:10 pm

Hi Richard,
I'm sure there is a parts listing on here somewhere for the TDS 6, but I'm not so familiar with them.
Denford did use a mix of threads over the years.
1.25mm is more likely 20tpi, so it could be 1/4" x 20 UNC or BSW. The difference is in the angle, 60 degrees or 55.
Might help if you can post a picture of where the screw is.

Andy

Andy B
CNC Guru
CNC Guru
Posts: 396
Joined: Mon 20 Nov , 2006 18:19 pm
Hardware/Software: 280 VS lathe, Denford Senior E-type mill, Senior Major Universal Mill
Location: East Midlands, UK

Re: Body part screw thread

Post by Andy B » Fri 12 Jun , 2020 19:37 pm

Page 329 of this download - http://www.denfordata.com/downloads/for ... imised.pdf - lists 1/4" BSW, so I expect that's what they are.

Andy

Andy B
CNC Guru
CNC Guru
Posts: 396
Joined: Mon 20 Nov , 2006 18:19 pm
Hardware/Software: 280 VS lathe, Denford Senior E-type mill, Senior Major Universal Mill
Location: East Midlands, UK

Re: Body part screw thread

Post by Andy B » Mon 15 Jun , 2020 17:25 pm

Why do people ask questions and never acknowledge the answers?

rpwilson
CNC Expert
CNC Expert
Posts: 155
Joined: Tue 03 Jun , 2014 15:20 pm
Hardware/Software: None. I own a pre CNC Denford 280 Synchro lathe.

Re: Body part screw thread

Post by rpwilson » Mon 15 Jun , 2020 20:24 pm

Because they are not as well brought up as what we are, Andy

Post Reply