Hi
I have been advised by a Denford rep that I can remove all filters and run a tube from the bottom extraction port through the wall to extract to the outside and the machine will work well and will never need a filter again. Given the rising costs of filters and the falling funding of my dept this appears to be a good option.
Any advise / comments?
Extracting VL 300 to outside thru wall.
Moderators: Martin, Steve, Mr Magoo
- Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: Extracting VL 300 to outside thru wall.
See this post I've just done on extraction:
viewtopic.php?f=5&t=2612
viewtopic.php?f=5&t=2612