All info relating to the Denford Triton and Triton Pro milling machines. (Project Lead the Way)

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
Posts: 8
Joined: Thu 25 Jan , 2007 18:31 pm


Post by goonies » Fri 02 Feb , 2007 17:03 pm

If I wanted to use a generic post processor for a Denford Triton CNC Mill, which out of this list would work?

parametric horizontal ab table unit.mcp
parametric horizontal ab trunnion inch.mcp
parametric horizontal b inch.mcp
solid horizontal ab trunnion.mcp
solid vertical ac trunnion.mcp
solid vertical as unit.mcp
solid vertical ba table unit.mcp

All of these posts are built into EdgeCAM you would think one of them wourd work, but which one?

User avatar
Denford Admin
Site Admin
Posts: 3593
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse

Post by Denford Admin » Fri 02 Feb , 2007 17:29 pm

Try one of the Fanuc ones first, eg the fanuc3x-in

That will be closest on g-codes, although if Edgecam tries to use canned cycles, then you may hit problems.

User avatar
Triac whizz
CNC Expert
CNC Expert
Posts: 238
Joined: Mon 17 Jul , 2006 21:48 pm
Location: France

Post by Triac whizz » Fri 02 Feb , 2007 18:40 pm

Have you tried contacting Edgecam?
Self Catering Lodges in Central France with covered pool & large grounds

Posts: 8
Joined: Thu 25 Jan , 2007 18:31 pm

Post by goonies » Sun 04 Feb , 2007 21:01 pm

I have contacted edgeCAM and they give me the run around. I am a Project Lead the Way teacher and they keep referring me to PLTW instead. I will try the fanuc ones tomorrow at school. Thanks.

Post Reply