Just for giggles I've uploaded a video of my Triac hammering a 18mm U drill through ali at 3500rpm and 200mm/min, the vid goes on and shows the whole job, there's no interval for popcorn & ice cream I'm afraid
http://video.google.co.uk/videoplay?doc ... 7361361204
broadband recomended
Triac at work video
Moderators: Martin, Steve, Mr Magoo
- Triac whizz
- CNC Expert
- Posts: 238
- Joined: Mon 17 Jul , 2006 21:48 pm
- Location: France
Triac at work video
Self Catering Lodges in Central France with covered pool & large grounds
www.la-coterie.com
www.la-coterie.com
- davidimurray
- CNC Expert
- Posts: 194
- Joined: Thu 24 Aug , 2006 9:45 am
- Triac whizz
- CNC Expert
- Posts: 238
- Joined: Mon 17 Jul , 2006 21:48 pm
- Location: France
Fanuc controls - out of the box as it left Denfords, give or take a few parameter changes
Self Catering Lodges in Central France with covered pool & large grounds
www.la-coterie.com
www.la-coterie.com
- Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
- Triac whizz
- CNC Expert
- Posts: 238
- Joined: Mon 17 Jul , 2006 21:48 pm
- Location: France
It's a bearing block see viewtopic.php?t=342 the thingys on the right
Guarding? It's all there - for what its worth but it was down for the video and I can't put it right up when I have a vice on the table - and wellies are obligatory when using suds! Is there something missing then? perhaps a cagoule?
Guarding? It's all there - for what its worth but it was down for the video and I can't put it right up when I have a vice on the table - and wellies are obligatory when using suds! Is there something missing then? perhaps a cagoule?
Self Catering Lodges in Central France with covered pool & large grounds
www.la-coterie.com
www.la-coterie.com