Page 2 of 2

Re: electrical power control box to machine

Posted: Mon 04 Feb , 2019 14:37 pm
by martin.pearson
Nothing on the Uniport I can see or read lol, you might have problems getting in touch as I believe the company that makes them has changed hands a couple of times. I do have another BOB on my other machine, the uniport was the first BOB I bought so is now a spare, I bought a second one when I upgraded the motion control to ethernet.
I can pull that one off the machine to test the denford if you think it might work, it has a higher voltage input so don't know if that would help. This is the one I have on the gerber system 48

https://www.cnc4you.co.uk/Breakout-Boar ... harge-Pump

Re: electrical power control box to machine

Posted: Mon 04 Feb , 2019 15:19 pm
by DavidB
The data sheet is fairly lacking in detail about the outputs, page 5 gave me hope that the output levels could be changed to 12V but all else indicated to me step/dir at 0 and 5V. The levels would need to be confirmed with the supplier or the output chips identified. The included picture shows markings but not in enough detail to read. If outputs at 0 5V then it won't likely drive the Parker cards.