Denford Triac Spindle Motor
Posted: Tue 28 Aug , 2018 16:00 pm
Hi,
I have a Denford Triac,
I would like to use it with a 0.8 mm slot drill/end mill to cut a 0.5 mm deep feature in Silver.
My choices as I see it are,
1. Attach a fast spindle motor on the side like a die grinder
2. Change the pulley ratio on the existing spindle to increase rpm closer to desired speed.
Please if anyone has any other ideas / suggestions or can see any problems with my ideas please let me know.
Jeremy
I have a Denford Triac,
I would like to use it with a 0.8 mm slot drill/end mill to cut a 0.5 mm deep feature in Silver.
My choices as I see it are,
1. Attach a fast spindle motor on the side like a die grinder
2. Change the pulley ratio on the existing spindle to increase rpm closer to desired speed.
Please if anyone has any other ideas / suggestions or can see any problems with my ideas please let me know.
Jeremy