Page 1 of 1

Spindle Pulley pitch/Spec

Posted: Mon 03 Aug , 2015 19:31 pm
by andy_con
does anyone know the exact spec of the spindle/powered draw bar pulleys?

the belt has 18 teeth

belt reads

150 l
k9

gap between teeth on belt is about 5mm

im pretty sure the pitch is 5mm just wanted to check

Image

Image

Re: Spindle Pulley pitch/Spec

Posted: Mon 05 Oct , 2015 12:01 pm
by Chaz
Are you still looking for info on this? Ive got all the details at home, can upload them once I get home tonight if still needed.

Re: Spindle Pulley pitch/Spec

Posted: Wed 07 Oct , 2015 23:06 pm
by andy_con
Chaz wrote:Are you still looking for info on this? Ive got all the details at home, can upload them once I get home tonight if still needed.
that would be handy thanks