Triac keeps tripping my RCD - help
Posted: Fri 08 May , 2015 16:43 pm
my triac is connected to an RCD, I turn the triac on and everything is fine, I can move all axis around and its all good, start the spindle and then aboutg 5 second later the RCD trips.
checked with a multi meter and doesn't seem to be any connection between motor and ground.
Ive had many issues with my sem motor, so I sent it away for repair to a proper repair place. ive only had it back a month, been using it fine until yesterday when this started happening.
anyone offer any thoughts?
checked 17 and and 19 to ground on the spring drive card and no reading
checked 18 and 19 on the SRR and no reading
checked with a multi meter and doesn't seem to be any connection between motor and ground.
Ive had many issues with my sem motor, so I sent it away for repair to a proper repair place. ive only had it back a month, been using it fine until yesterday when this started happening.
anyone offer any thoughts?
checked 17 and and 19 to ground on the spring drive card and no reading
checked 18 and 19 on the SRR and no reading