Part needed please

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
PDodds
CNC Apprentice
CNC Apprentice
Posts: 35
Joined: Wed 09 Nov , 2011 17:17 pm
Hardware/Software: Triac '87 converted to mach3
Orac '85 converted to mach3

Part needed please

Post by PDodds » Wed 12 Nov , 2014 16:27 pm

Hi,

Does anybody have a spare spindle motor pulley for a green triac?

It has a 14mm diameter bore, with a 5mm keyway broached in.
It has 14 splines on it for the timing belt.
It is the one which goes on the output shaft of the motor.
The diameter across the pulley is 42mm.

Maybe Denford carry them on stock still?

Any help in locating one would be greatly appreciated.

Cheers
Paul

User avatar
Lone_Ranger
CNC Expert
CNC Expert
Posts: 220
Joined: Mon 01 Oct , 2007 15:23 pm
Contact:

Re: Part needed please

Post by Lone_Ranger » Sat 15 Nov , 2014 1:08 am

PDodds wrote:Hi,

Does anybody have a spare spindle motor pulley for a green triac?

It has a 14mm diameter bore, with a 5mm keyway broached in.
It has 14 splines on it for the timing belt.
It is the one which goes on the output shaft of the motor.
The diameter across the pulley is 42mm.

Maybe Denford carry them on stock still?

Any help in locating one would be greatly appreciated.

Cheers
Paul
Try these folks, they will be able to sort out the right gear for you to your specs and not too expensive :D

http://www.hpcgears.com/n/products/1.pu ... _belts.php

Regards
Rob

Post Reply