Page 1 of 1

Back Lash on X

Posted: Fri 30 May , 2014 14:47 pm
by andy_con
got about 0.1mm of back lash on the x table, anyone got any tips to reduce it?

tightened the screw for each gib by about half a turn but didn't make any odds

Re: Back Lash on X

Posted: Fri 30 May , 2014 15:20 pm
by Martin
Tab Nut.

You will need to remove the X axis stepper motor & the Pulley on the end of the Lead screw. You will then see the Tab Nut & Tab Washer. You can push the Tab back then tighten the nut & lock it with the Tab.

Re: Back Lash on X

Posted: Fri 30 May , 2014 15:29 pm
by andy_con
um interesting maybe when I had to change the bearings in the x table I didn't do it up properly.

how tight should I do it?

thanks for the help

Re: Back Lash on X

Posted: Fri 30 May , 2014 16:31 pm
by andy_con
is this normal?

the table moves back and forth pretty easily (and no its not the vice that's moving)

[video]https://www.youtube.com/watch?v=tXiMJb4 ... e=youtu.be[/video]

https://www.youtube.com/watch?v=tXiMJb4 ... e=youtu.be

Re: Back Lash on X

Posted: Fri 30 May , 2014 20:52 pm
by andy_con
sorted the issue above, but here is my 0.1mm backlash issue

https://www.youtube.com/watch?v=nf5j6zR ... e=youtu.be

any suggestions?

Re: Back Lash on X

Posted: Fri 30 May , 2014 22:56 pm
by Martin
TAB NUT!

Re: Back Lash on X

Posted: Fri 30 May , 2014 23:01 pm
by andy_con
lol

tightened the tab nut, but its made no difference

how tight? till it wont turn anymore?

Re: Back Lash on X

Posted: Wed 11 Jun , 2014 22:22 pm
by andy_con
well with a bit of help from tom I started taking the table completely to bits to try work out the problem

although the backlash issue is 100% not the ball screws, the ball screws are very very sticky. turns out the oiler isn't working which could well be the cause.

there doesn't seem to be any play/movement in the ball screws just very sticky (yes I have oiled), so its either leave the ball screws knowing that at some point in the near future they are going to need sorting or doing it now.

the sleeve that's needed to take the threaded bar out, anyone know what one I need and where to buy from? a link would be handy.

Image

also this screw which is for the jib is fooked, I didn't do this it was already like it. anyone know where to get a new one?

Image

Re: Back Lash on X

Posted: Thu 03 Jul , 2014 12:43 pm
by andy_con
anyone got any tips for tightening the tab nut?

when im tightening the table is moving making it hard to do up tight