A few questions regarding the Triac Atc

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
Posts: 2
Joined: Fri 04 Apr , 2014 10:41 am
Hardware/Software: 1988 denford triac atc fanuc om control
no external software as of yet

A few questions regarding the Triac Atc

Post by Booey85 » Sun 06 Apr , 2014 22:48 pm

I've being offered a Denford Triac Atc 1988 fanuc OM control, I was wondering what's a rough value for these machines? And how can I find out how many hours it's run, any other information would be greatly appreciated

The serial number is Tr 29078f
The electronics serials are 8044116

Also I read a post on here where somebody had made a break out board to connect to mach3 without replacing all of the electronics. is it possible to buy one of these or get the plans? Thanks again

Post Reply