Denford Software & Machines

Posted: **Sat 05 Apr , 2014 18:44 pm**

Hi
I have some issues with my TRIAC. It should mill this cylinder following the blue line(10 steps Z-axis cut increment 1.5mm) but suddenly after done that in 2 steps(z-axis) it starts to short cut and follows the red line. I cant seem to find anything wrong in the NC code I'm using EdgeCam. Can it be something wrong with the stepper motors or some thing else ?

Posted: **Sat 05 Apr , 2014 19:45 pm**

What software is driving the machine & what control/eprom?

Posted: **Sun 06 Apr , 2014 10:49 am**

Fanuc 0M (Denford Fanuc milling 2.73 with the tutor panel). Where can I find the eprom ?

Posted: **Sun 06 Apr , 2014 12:18 pm**

what position physically is the slot, in the x or y axis, or between

Posted: **Tue 08 Apr , 2014 19:23 pm**

It is between the X and Y axis.

Posted: **Tue 08 Apr , 2014 20:49 pm**

I thought it was going to be a VRMilling issue but not too sure regarding the Dos software.

Denford Software & Machines

problem doing circles

problem doing circles

Re: problem doing circles

Re: problem doing circles

Re: problem doing circles

Re: problem doing circles

Re: problem doing circles