My x belt just snapped again, this is the second time in a few months.
The bed wasn't even under any pressure it was doing a tool change at the time. I notice when replacing there is no adjustment tor tension on the belt.
Any suggestions?
x belt keeps snapping
Moderators: Martin, Steve, Mr Magoo
Re: x belt keeps snapping
The only time I have seen the X axis drive belt snap on the Triac is when the axis has been driven to the end of its limit & then stalls while the motor is still turning/
In order to tension the belt you just need to push down lightly on the motor assembly as you fasten it on.
In order to tension the belt you just need to push down lightly on the motor assembly as you fasten it on.