x belt keeps snapping

All info relating to the Denford Triac series of CNC milling machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
andy_con
CNC Expert
CNC Expert
Posts: 188
Joined: Fri 05 Oct , 2012 20:06 pm
Hardware/Software: Triac Vmc with 6 station ATC
Starmills with ATC

x belt keeps snapping

Post by andy_con » Fri 19 Jul , 2013 19:17 pm

My x belt just snapped again, this is the second time in a few months.

The bed wasn't even under any pressure it was doing a tool change at the time. I notice when replacing there is no adjustment tor tension on the belt.

Any suggestions?

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: x belt keeps snapping

Post by Martin » Sat 20 Jul , 2013 6:47 am

The only time I have seen the X axis drive belt snap on the Triac is when the axis has been driven to the end of its limit & then stalls while the motor is still turning/

In order to tension the belt you just need to push down lightly on the motor assembly as you fasten it on.

Post Reply