Denford Software & Machines

Machine was doing its thing and the X stopped working.

took the stepper out and i have a broken belt, help!

how/where do i get a replacement from and how do i replace it?

belt replaced

where is the Y servo? would it be located under the Z column?

yes it is, access is from the back.

ah ok, is there a panel or something?

due to the limited space in my workshop i cant access the back of the machine to check, so just thought id make enquiries encase i get any issues

it's at the base of the pillar.

cool thanks, hopefully i wont need to move the machine but you never know

if you intend to replace the y belt you'll need a fair bit of room as it's a little bit tight to get at it.

no i only plan to replace it if it breaks, otherwise im leaving it alone.

should i even ask where the z belt is?

inside the pillar, if you take off the pillar top plate you'll see it.

ok cool thanks