Denford Software & Machines

Hi all, can anyone tell me what the air demand is to run the atc on a Triac and any recommendations on which compressors do the job nicely, preferably a quiet running type!

Thankyou, Rich.

Hi Rich,
The ATC has very little demand as you are only filling, if I remember correctly, three small cylinders and only the two that drives the carousel in and out and up and down are double acting; the spindle release is air operated but spring return. I don't even have my compressor running as there is usually plenty of air in the receiver. I have a Hydrovane HV02 as I live in a terraced house and it's dead quiet but any small compressor will do as long as it is fitted with an air receiver.

...Sweep

ricky b wrote:Hi all, can anyone tell me what the air demand is to run the atc on a Triac and any recommendations on which compressors do the job nicely, preferably a quiet running type!

Thankyou, Rich.

I use one of these http://www.machinemart.co.uk/shop/produ ... ressor-524 very, very quiet, the motors are basically like fridge motors and are only a little louder than the average fridge, worth every penny

Runs all my air guns and a Mill with ATC without any problems.

Regards
Rob


.

Thanks Rob, not logged in for a while, once again thanks!

Rich